Introduction to 3D Printing: Personalised Keyring
Would you like to know more about using 3D printers? Sign up for this session, become a MakerPlace member and learn the basics of 3D design. You'll also learn how to use our equipment safely on your own.
Find out how you can become a MakerPlace member and use our digital fabrication equipment on your own. These sessions cover how to prepare your files and use our equipment safely. Please note, you must be able to use a keyboard and mouse confidently to attend these sessions.
As 3D printing takes a long time, your print will need to be collected at a later point. We will contact you to let you know that your print is ready for collection, or we are able to send the print to any Gateshead Council Library for collection.
Late Arrivals: It will not be possible to join a workshop if you arrive more than 15 minutes late. By this time in a workshop, technical knowledge will have been covered and it won't be possible to go back over this information.
Resources: All resources are included in the cost of the ticket for this event. Unless stated otherwise, you do not need to bring anything with you to participate.
Mobile Phones: We ask that mobile phones are not used during a workshop.
Food and Drink: Only covered beverages are allowed in the MakerPlace, we ask that you keep drinks away from the equipment and computers. No food is to be consumed in the MakerPlace.
Refunds: Please see our Gateshead Libraries Event Terms and Conditions for our refund and cancellation policy.